Brandmeister reflector list5/16/2023 The use of your repeater’s local talkgroup (if applicable) is always permitted. For international, national, and regional QSO’s, stations should move their transmissions to one of the DMR-MARC UA talkgroups or to the DCI TAC-310 talkgroup.įor intrastate contacts, stations may use their area’s statewide talkgroup (if applicable). After contact is established, stations should utilize as few resources as possible. DMRĪll wide area talkgroups are permitted for use for JOTA for establishing contacts. Always listen first to avoid interfering with another QSO. * 145.670 and 438.010 are commonly used as the National D-STAR Simplex Channels and should be used only as Calling Channels for JOTA. After contact is established, stations should disconnect from REF033A and connect to one or other repeater or migrate to an unused Reflector. REF033A has been allocated as a full-time JOTA/Radio Scouting D-STAR Reflector. Always listen first to avoid interfering with another QSO or auxiliary or control link. Avoid 146.520, the National FM Simplex Calling Frequency, as well as 146.550, which is commonly used by mobiles and RVers. The chart below shows the commonly used frequencies for PSK-31. Use the standard frequencies as set in the WSJT-X software. While demonstrations are somewhat dry, this mode does allow you to work stations and countries that you couldn’t otherwise hear. See also below the information on the Worked All Germany Contest (WAG), which has designated contest-free frequencies to accommodate Jamboree on the Air.įT8, MSK144, etc. Also the 30 m, 17 m, and 12 m bands are contest-free. Feel free to move your transmission to find a clear spot. There are several state QSO parties (contests) held that same weekend.WOSM (World Organization of the Scouting Movement) calling frequencies are shown to indicate center of international activity.Use web search tools to find lots of helpful information about any of the modes commonly used for JOTA and Radio Scouting.Experiment with modes prior to JOTA or any Radio Scouting demo.You can also start calling CQ at other frequencies near the calling channel. After contact is made on a Calling Channel or frequency, move to another channel or frequency for your QSO.Technicians may take advantage of 10 meters and VHF/UHF for voice communications. Primary HF recommendations are for General Class licensees.All frequencies are shown as megahertz.If someone else is already on that frequency, move up or down to find a clear frequency for calling. As with all amateur radio frequencies they are a shared resource. These were initially suggested by the World Organization of the Scout Movement and their Jamboree on the Air organizer. Here’s detailed information on frequencies suggested as Scout amateur radio frequencies.
0 Comments
Leave a Reply. |